The Frame Relay interface actually consists of one physical connection between the network server and the switch that provides the service. The figure below illustrates the connections among the components.įigure 1. The CSU/DSU converts V.35 or RS-449 signals to the properly coded T1 transmission signal for successful reception by the Frame Relay network. However, a single device interface configured for Frame Relay can be configured for only one of these methods. You can create Frame Relay connections using one of the following hardware configurations:ĭevices and access servers connected directly to the Frame Relay switchĭevices and access servers connected directly to a channel service unit/digital service unit (CSU/DSU), which then connects to a remote Frame Relay switchĭevices can connect to Frame Relay networks either by direct connection to a Frame Relay switch, through a direct connection to a Point of sale (POS) interface or a T1/T3 interface, or through CSU/DSUs. Relay traffic shaping is not supported on frame relay main interface. To access Cisco Feature Navigator, go toįrame-relay traffic shaping (Cisco IOS XE software supports only policy Navigator to find information about platform support and Cisco software image Which each feature is supported, see the feature information table. The features documented in this module, and to see a list of the releases in Release notes for your platform and software release. May not support all the features documented in this module. The Cisco IOS XE Frame Relay implementation currently supports routing for IPv4, IPv6, and Multiprotocol Label Switching (MPLS). Feature Information for Configuring Frame Relayįrame Relay is a high-performance Wide Area Network (WAN) protocol that operates at the physical and data link layers.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |